01
Walkthrough and camera scan
We start by walking the house with you and noting every register, return and the dryer vent termination. A duct inspection camera goes into the main trunk and the dryer run so we can see what is actually in there before we touch anything. This takes about 15 minutes and tells us whether you need standard cleaning or something heavier.
02
System setup and containment
We lay drop cloths, tape off registers we are not working, and tie the negative air machine into the trunk line. Everything we loosen gets pulled into a HEPA vacuum, so dust does not migrate into your furniture or your kitchen. Setup usually runs 20 to 30 minutes on a typical Lewisville three-bedroom.
03
Duct cleaning
A rotary brush system and air whip work each branch line from the register back to the trunk. Stubborn buildup at the boot gets a compressed air nozzle. We work section by section, and the negative air machine stays running the whole time so loosened debris has one direction to travel: out.
04
Dryer vent cleaning
We disconnect the dryer, brush the full length of the vent, and vacuum the lint trap housing and blower wheel. The exterior termination gets checked for a stuck flapper or a bird screen packed with lint. If the run is long or has multiple elbows, we verify airflow at the cap before we reconnect anything.
05
Verification and photos
We re-scan the trunk with the camera, confirm the dryer is pushing air hard at the exterior cap, and reseal any joints we opened with mastic or foil tape. You get before-and-after photos of both systems and a plain-English rundown of what we found. Total visit runs two to four hours for most homes.